Jump to content
NAKIVO Community Forum

Leaderboard

Popular Content

Showing content with the highest reputation on 04/28/21 in Posts

  1. Hi, I have a script which ejects the medium after the job (via "post job script") and sends e-mails to employees to replace the medium. But this is also called if there was an error during the Job (failed run). (On failure the execution of the scrip should be stopped) How can I control the script so that it is only called if the job is executed successfully? Can I somehow run a script only as a job? Then I could start this as a following job if the main-job was successful ("Run this job After successful runs"). Or is there another way to control the execution of the scrips? Kind Regards Jens System: Synology DS920+, NAKIVO 10.2.0 (build 53298 from 31 Mar 2021); Tandberg RDX USB 3.0
    1 point
  2. Hi, I deleted the restore job because I "experimented" with the jobs But I believe that I did the restore in "Production mode". So the same vc.uuid was used in the vmx file and the backup found the wrong VM (Murphy says hello: ). I think the "Recovery mode" was the reason. Kind regards, Jens
    1 point
×
×
  • Create New...